diff --git a/Examples/MotionMote/MotionMote.ino b/Examples/MotionMote/MotionMote.ino index 8b9a225..0beb97a 100644 --- a/Examples/MotionMote/MotionMote.ino +++ b/Examples/MotionMote/MotionMote.ino @@ -41,23 +41,23 @@ //********************************************************************************************* //************ IMPORTANT SETTINGS - YOU MUST CHANGE/CONFIGURE TO FIT YOUR HARDWARE ************* //********************************************************************************************* -#define NODEID 86 //unique for each node on same network +#define NODEID 123 //unique for each node on same network #define NETWORKID 100 //the same on all nodes that talk to each other #define GATEWAYID 1 //Match frequency to the hardware version of the radio on your Moteino (uncomment one): #define FREQUENCY RF69_915MHZ #define ENCRYPTKEY "sampleEncryptKey" //exactly the same 16 characters/bytes on all nodes! #define ENABLE_ATC //comment out this line to disable AUTO TRANSMISSION CONTROL -#define ATC_RSSI -85 //at -85 it works 50% +#define ATC_RSSI -90 //********************************************************************************************* #define ACK_TIME 30 // max # of ms to wait for an ack -#define ONBOARDLED 9 // Moteinos have LEDs on D9 -#define PIR_POWER 7 -#define MOTION_PIN 3 // D3 +#define ONBOARDLED 9 // same as LED_BUILTIN on Moteinos (D9) +#define PIR_POWER 7 // PIR is powered from D7 +#define MOTION_PIN 3 // PIR output #define MOTION_IRQ 1 // hardware interrupt 1 (D3) - where motion sensors OUTput is connected, this will generate an interrupt every time there is MOTION #define DUPLICATE_INTERVAL 20000 //avoid duplicates in 55second intervals (ie mailman sometimes spends 30+ seconds at mailbox) #define BATT_INTERVAL 300000 // read and report battery voltage every this many ms (approx) -const uint16_t INTERNAL_AREF_V = 1091; +const uint16_t INTERNAL_AREF_V = 1100; //measured internal 1.1v bandgap #define LED_PWR 6 #define LED_GND 5